43) LIST OF ENGINEERING TOPICS FOR LETTER "O"

Observability
Observability, in control theory, is a measure for how well internal states of a system can be inferred by knowledge of its external outputs. The observability and controllability of a system are mathematical duals.

Formally, a system is said to be observable if, for any possible sequence of state and control vectors, the current state can be determined in finite time using only the outputs (this definition is slanted towards the state space representation). Less formally, this means that from the system's outputs it is possible to determine the behaviour of the entire system. If a system is not observable, this means the current values of some of its states cannot be determined through output sensors: this implies that their value is unknown to the controller and, consequently, that it will be unable to fulfil the control specifications referred to these outputs.


Ohm's law
Ohm's law applies to electrical circuits; it states that the current through a conductor between two points is directly proportional to the potential difference or voltage across the two points, and inversely proportional to the resistance between them.

Operational amplifier
An operational amplifier, which is often called an op-amp, is a DC-coupled high-gain electronic voltage amplifier with differential inputs and, usually, a single output. Typically the output of the op-amp is controlled either by negative feedback, which largely determines the magnitude of its output voltage gain, or by positive feedback, which facilitates regenerative gain and oscillation. High input impedance at the input terminals (ideally infinite) and low output impedance (ideally zero) are important typical characteristics.

Op-amps are among the most widely used electronic devices today, being used in a vast array of consumer, industrial, and scientific devices. Many standard IC op-amps cost only a few cents in moderate production volume; however some integrated or hybrid operational amplifiers with special performance specifications may cost over $100 US in small quantities.

Modern designs are electronically more rugged than earlier implementations and some can sustain direct short circuits on their outputs without damage.

The op-amp is one type of differential amplifier. Other types of differential amplifier include the fully differential amplifier (similar to the op-amp, but with 2 outputs), the instrumentation amplifier (usually built from 3 op-amps), the isolation amplifier (similar to the instrumentation amplifier, but which works fine with common-mode voltages that would destroy an ordinary op-amp), and negative feedback amplifier (usually built from 1 or more op-amps and a resistive feedback network).

Optimal control
Optimal control theory, an extension of the calculus of variations, is a mathematical optimization method for deriving control policies. The method is largely due to the work of Lev Pontryagin and his collaborators in the Soviet Union and Richard Bellman in the United States.